Table of Contents
Advertisement
to other devices (e.g. VCR/Monitors), set the associated DIP switch to the
UP position to ensure correct termination.
The DIP switches on the interface board are not used.
3. Ensure that the designated trigger zones on the control panel are installed
4. Connect the Keybus terminals of the V4000 module to the control panel's keypad
(ECP) bus using 22AWG (5mm), quad, twisted two-pair wire.
5. Connect an ADEMCO AD12612, 12VDC, 1A power supply to the Power In
terminals on the V4000.
Caution: Ensure that the correct polarity is observed when connecting to the
power source.
Caution: Ensure that the negative power input, negative power output, circuit
common, and unit chassis are tied together in the V4000 Video Module.
6. Power-up the system.
Figure 2: System Wiring
8
Advertisement
Table of Contents
