Emergency Stop Switch Check; Adjust Belt Tracking - GE Series 2000 Installation Instructions Manual

Emergency Stop Switch Check

Adjust Belt Tracking

2021403-028A
NOTE
On the CASE system, connect the Series 2000 treadmill interface cable
in the one of the following ports: COM 1, COM 2, COM C or COM D. The
CASE RSS modem requires the use of either COM 1 or COM 2. Move the
treadmill interface cable to COM C or COM D only as necessary.
2. Turn the Series 2000 Treadmill power switch ON.
3. Turn the controlling device power switch ON.
1. Manually control the speed of the Series 2000 Treadmill from the controlling
device. With the belt moving at a relatively high speed, press the emergency
STOP switch. The treadmill belt will stop promptly but the belt will not lock,
allowing for removal of foreign objects. To release the switch, turn the button
1/4-inch turn in either direction.
2. Use the controlling equipment to terminate the exercise session and turn off
the treadmill.
WARNING
MOVING PARTS — Keep hands, hair, jewelry and loose
clothing away from moving parts.
1. Use the controlling equipment to set the belt speed to 4 or 5 miles per hour (7
or 8 kilometers per hour).
2. To correct a belt that tracks to the right, using a 9/16 or 15 mm socket
wrench, turn the right pulley adjustment screw CLOCKWISE in 1/8-turn
increments until the belt tracks in the center. Wait 2 or 3 minutes between
each 1/8-turn to allow the belt position to stabilize.
To correct a belt that tracks to the left, turn the left pulley adjustment screw
CLOCKWISE in 1/8-turn increments until the belt tracks in the center. Wait
2 or 3 minutes between each 1/8- turn to allow the belt position to stabilize.
NOTE
Make adjustments to the pulley screws in small increments. Over
adjustments and repeated tightening of the screws can cause too much
tension on the belt.
Series 2000 Treadmill 9