Huawei eSpace 6870 Quick Start Manual page 5

Configuring a Static IP Address for the eSpace 6870
By default, the IP address of the eSpace 6870 is configured in DHCP
mode. If your PC obtains the IP address from the network in DHCP mode,
skip this section.
Perform the following steps to configure a static IP address for the eSpace 6870.
Step 1
Press MENU (the round button in the center of the arrow keys) to access the
menu.
Step 2
Choose Network. Press MENU to access the Network menu.
Step 3
Access the IP Setting menu and press DOWN to select STATIC IP (DHCP
by default).
Step 4
Access the IP menu and press BackSpace to delete all the default values, and
then type the static IP address. Press OK to confirm and exit.
Step 5
Configure Netmask and Gateway by using the same method.
Step 6
Press MENU to return to the Config menu after setting Gateway. Press
LEFT to return to the main menu.
Step 7
Choose Reboot, and then Press MENU to reboot the eSpace 6870.
Configuring Basic SIP Information in Web Mode
The web-enabled computer has to be connected to the same sub-network as the phone.
This can easily be done by connecting the computer to the same hub or switch as the
phone is connected to. In absence of a hub/switch (or free ports on the hub/switch),
connect the computer directly to the phone by using the PC port on the phone. Make
sure the phone is powered on and displays the IP address. To access the web
configuration menu of the phone, do as follows:
Step 1
Open the Web browser such as the Internet Explorer. Type
http://192.168.0.160/ in the address bar and press Enter to display the login
page.
Where, 192.168.0.160 is the IP address of the eSpace 6870.
Step 2
Type the administrator password, and then click Login.
The default administrator password is admin.
Step 3
After login, click the Accounts tab to display the configuration page, as
shown in Figure 3-1. Table 3-1 lists the information that you must configure.
Figure 3-1 Configuration page
5