Setting The Disklavier For Audio Data Reception/Transmission - Yamaha Disklavier E3 Update Manual

Setting the Disklavier for Audio Data Reception/Transmission

(Additional Features)
[SETUP] "AudioI/O"
You can select the kind of the incoming/going out audio signals. The following
options are available in version 2.10.
OMNI IN
Auto Detect: Select this when you make the Disklavier detect the input signal
automatically.
OMNI OUT
SYNC: Select this when you output the SMPTE signal used for video
synchronization playback.
SYNC IN Offset
Adjusts the length of the offset time that leads the actual playback of entire
recording. The offset time can be set in a range of –500ms to +500ms.
Decrease this value to delay the piano playing, and increase to advance the
piano playing.
SYNC OUT Level
Adjusts the output level of the SMPTE signal. For normal use, the adjustment
of this option is not required. If noises (synchronized signal) are output from
the OUTPUT jacks during video synchronized playback, turn down the level
and re-record.
10