Table of Contents
Advertisement
• Wiring diagram
Internal Wire (white)
Controller (C) (16)[16]
Next, position the LED so as to fit it into the hole in the Housing (1)[1].
Here, be careful not to catch any LED Internal Wires (14)[14] on adjacent parts.
Also make sure that the internal wires connecting the Controller (C) (16)[16] to the Switch (13)[13] are
incorporated in order of red, black and white.
(6) Incorporate the Lock-off Button (3)[3] and Trigger (12)[12] into the corresponding positions in the
Housing (1)[1].
2. Reassembling the Gears
(1) When incorporating the First Gear (20)[20], apply grease (Hitachi Motor Grease No. 29) to the outer
circumference of Shaft (B) (19)[19], insert Shaft (B) (19)[19] into the Washer D15 (18)[18] and the First
Gear (20)[20], and then complete reassembly so that the retaining groove section and locking flat
section of Shaft (B) (19)[19] mate with the rib and flat portion of housing (A). Here, make sure that the
Washer D15 (18)[18] is incorporated into position.
(2) When incorporating the Final Gear (21)[21], apply grease (Hitachi Motor Grease No. 29) to the outer
circumference of Shaft (A) (23)[23], insert Shaft (A) (23)[23] into the Washer D15 (18)[18] and Final
Gear (21)[21], and then complete reassembly so that the retaining groove section and locking flat
section of Shaft (A) (23)[23] mate with the rib and flat portion of housing (A).
3. Reassembling the Housing
(1) When installing housing (B), which is a part of the Housing (1)[1], make sure that no internal wire is
loose or caught.
(2) Properly position housing (B), which is a part of the Housing (1)[1], and tighten the six Tapping Screws
(w/Flange) D4x20 (black) (9)[9] (while being careful not to catch any internal wires).
4. Reassembling the Blade Set
(1) Make adjustments so that the oval
section of the crank of the Blade Set (CH)
(38)/Blade Set (CG) (48)[24] is as shown
in the right figure.
The figure shows the oval section with the
upper and lower blades being staggered.
Internal Wire (black)
Internal Wire (white)
Trigger (12)[12]
Switch (13)[13]
LED
Lock-off button
Internal Wire (red)
Shrub shear
-12-
Motor
DC 10.8 V (17)[17]
Grass shear
Advertisement
Table of Contents
