Installing / Removing The Appliance(S) - Miele CS 1011 G Operating And Installation Instructions

Installing the appliance
^ Feed the connection cable down
through the cut-out.
^ Place the appliance into the worktop
cut-out, starting with the front of the
appliance.
^ Using both hands, press down
evenly on the sides of the appliance
until it clicks into position. When
doing this, make sure that the seal
sits flush with the worktop on all
sides. This is important to ensure an
effective seal all round. Do not use
sealant.
When installing several appliances, a
cover must be inserted into the spacer
bar.
^ Slide the installed appliance to one
side until you can see the holes of the
spacer bar.
^ Insert the cover d into the holes of
the spacer bar b.

Installing / removing the appliance(s)

^ Place the appliance into the worktop
^ Connect the appliance to the mains
^ Check that the appliance works.
Removing the appliance
If the appliance is accessible from
below, push it out from underneath,
starting at the back.
If the appliance is not accessible from
below, take hold of the appliance with
both hands at the back, pull it forwards,
then lift it up and out.
cut-out, starting with the front of the
appliance.
(see "Electrical connection").
39