Table of Contents
Advertisement
Operating Instructions
®
Busch-Wächter
Pos: 24 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/1. Ebene/G - L/Inbetriebnahme @ 11\mod_1279185496977_15.docx @ 83035 @ 12112 @ 1
6
Commissioning
Pos: 25 /#Neustruktur#/Online-Dokumentation (+KNX)/Inbetriebnahme/Waechter/Inbetriebnahme - 6842 @ 25\mod_1340605710889_15.docx @ 219933 @ 12112 @ 1
6.1
Removing the protective foil
Fig. 5:
Protective foil on the battery
1. Remove the protective foil from the battery before commissioning.
6.2
Programming the device
Fig. 6:
Remote control
2. Press the "AUTO" button on the remote control for at least 3 seconds within the period of 10 minutes after
activating the power on the Busch-Watchdog.
-
The Busch-Watchdog must be de-energized for at least 30 seconds.
-
The remote control will then automatically connect itself to the Busch-Watchdog, and the Busch-
Watchdog will flash if the reception is correct.
-
Repeat these steps to program a maximum of 9 additional remote controls.
Pos: 26 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/1. Ebene/U - Z/Wartung @ 21\mod_1328188606500_15.docx @ 138248 @ 112 @ 1
7
Maintenance
Pos: 27 /#Neustruktur#/Online-Dokumentation (+KNX)/Wartung/Waechter/Wartung - 6842-101 @ 25\mod_1340608294922_15.docx @ 219948 @ 2 @ 1
7.1
Battery change of remote control
+
CR 2025
Fig. 7:
Changing the battery
1. Pull the battery holder out of the remote control.
2. Insert a new battery of type 2025. The plus pole of the battery (+) must be on top.
3. Push the battery holder back into the device.
=== Ende der Liste für Textmarke Content ===
Operating Instructions | 1473-1-8141
Commissioning
— 11 —
Advertisement
Table of Contents
