Advertisement
CLEANING OR REPLACING THE BRUSHES
To replace the brushes (or to clean them) carry out
the following sequence of operations:
The machine must be switched on but all functions
switched off; it means that the squeegee must be
lifted.
Raise the brush unit by pressing down the relevant
pedal and latching it in its lowest position.
Press the brush release push button A momentarily
(1 or 2 seconds) and the brushes will be unloaded
from the machine.
Move the machine backward by rolling the drive
control thumb wheels rearward until the brushes
are visible in front of the machine.
(pull the machine that is not equipped with the
drive motor).
Clean carefully the three pins of each brush to
keep efficient the Click ON/Click OFF function.
To mount the new brushes see the "Preparation for
use" at page 10.
18
Partially unscrew the two middle levers on the
squeegee. Push the squeegee into the locating
lugs as illustrated and fully tighten the hand-levers.
(Pull the lever up to disingage it and make its
rotation free).
A
ON
OFF
Push the coiled end of the squeegee hose fully
home onto the tubular spigot in the centre of the
squeegee.
Push the straight end of the squeegee hose onto
the tank inlet pipe which protrudes through a slot
in the rear panel.
PREPARATION FOR USE
7
Hide quick links:
Advertisement
