3.2.11 Installing/Removing the Optional Service Cards
3.2.11 Installing/Removing the Optional Service Cards
CAUTION
•
To protect the back board from static electricity, do not touch parts on the back board in the main unit
and on the optional service cards. To discharge static electricity, touch ground or wear a grounding
strap.
•
When installing or removing the IPCEMPR card, BUS-M card or BUS-S card, the DC power supply
must be turned off.
Note
The optional service cards can be installed or removed while the DC power is supplied.
Installing Optional Service Cards
1.
Insert the card along the guide rails.
2.
Holding the card as shown below, push the release lever in the direction of the arrow so that the card
engages securely with the connector on the back board.
Release Lever
114
Installation Manual
Guide Rail
Back Board
Document Version 2009-12