Philips HP8270 User Manual

Register your product and get support at
www.philips.com/welcome
HP8270
EN User manual TH
คู ่ ม ื อ ผู ้ ใ ช้
ZH-TW
KO
1
Read this user manual carefully before you use the appliance and keep it
for future reference.
Specifications are subject to change without notice
© 2013 Koninklijke Philips Electronics N.V.
All rights reserved.
3140 035 34581
a
9
b
This appliance complies with all standards regarding electromagnetic
available today.
d
c
Environment
Do not throw away the appliance with the normal household
e
point for recycling. By doing this, you help to preserve the
f
environment.
2
g
h
Congratulations on your purchase, and welcome to Philips! To fully
www.philips.com/welcome.
The ActiveCare dryer has a unique and innovative
new sensor technology called the TempPrecision
designed to protect your hair from over-heating
and is much gentler on the scalp than conventional
English
dryers. The TempPrecision sensor is an infrared
sensor, that measures the temperature of your
hair while drying it and will ensure that it never
Important
overheats your hair and scalp. This gives advanced
protection to the hair from overheating the hair
and the scalp and therefore keeps your hair
healthier and shinier.
WARNING: Do not use this appliance near water.
We've already turned the sensor on so you can enjoy maximum
When the appliance is used in a bathroom, unplug it after use since
protection right from the start.
the proximity of water presents a risk, even when the appliance is
switched off. 3
WARNING: Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
1 Connect the plug to a power supply socket.
Do not insert metal objects into the air grilles to avoid
electric shock.
Never block the air grilles.
Before you connect the appliance, ensure that the voltage indicated
on the appliance corresponds to the local power voltage.
Do not use the appliance for any other purpose than described in
this manual.
When the appliance is connected to the power, never leave it
2
unattended.
Always unplug the appliance after use.
3
Never use any accessories or parts from other manufacturers or that
or parts, your guarantee becomes invalid.
switch
Do not wind the mains cord round the appliance.
If the mains cord is damaged, you must have it replaced by Philips, a
Temperature
order to avoid a hazard.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
» The LED ( ) will always light up when the sensor is switched on.
If the appliance overheats, it switches off automatically. Unplug the
appliance and let it cool down for a few minutes. Before you switch
4 Press the cool shot button
the appliance on again, check the grilles to make sure they are not
5 The appliance is equipped with ion function, which provides
additional shine and reduces frizz.
» When the function is on, a special odor may be smelt. It is normal
After use:
1 Switch off the appliance and unplug it.
2 Place it on a heat-resistant surface until it cools down.
3 Clean the appliance by damp cloth.
4 Keep it in a safe and dry place, free of dust. You can also hang it with
the hanging loop ( ).
5 Remove the concentrator or diffuser before you clean the appliance.
4
Introduction
If you need information e.g. about replacement of an attachment or if
you have a problem, please visit the Philips website at www.philips.com/
welcome or contact the Philips Consumer Care Center in your country.
Consumer Care Centre in your country, go to your local Philips dealer.
Dry your hair
For precise drying, attach the nozzle ( ) onto the hairdryer. The
comb with which you are styling your hair.
To enhance volume for curls and bouncy style, attach the diffuser
( ) onto the hairdryer. To disconnect the attachment, pull it off
the hairdryer.
You are recommended to use the styling nozzle ( ) only for
styling and use the Thermoprotect heat setting for this purpose.
) is on so that you are guaranteed to
have protection from overheating the hair.
) and temperature switch ( ) to
suitable positions.
settings function
Dry shower-wet hair quickly
Quick dry
Thermoprotect Provides the optimal drying
temperature and gives additional
protection from overheating
the hair
Gently dry the hair
Switch
(
and caused by the ions which are generated.
To turn the ion function on or off, slide the IONIC switch ( ) to
or .
Guarantee and service
1
2
3