1.4 D
•
It is possible to assign the minimum duration of the DTMF signal sent to the CO line port which has
been set to DTMF mode.
Programming References
PC Programming Manual
2.7.8 [1-1] Slot—LCO Port
→ Dialing Mode
→ DTMF Width
→ Pulse Speed
PT Programming Manual
[410] LCOT Dialing Mode
[411] LCOT Pulse Rate
[412] LCOT DTMF Minimum Duration
1.4.3
Dial Tone
Description
The following dial tones inform extension users about features activated on their extensions:
Each dial tone type has two frequencies, such as dial tone 1A and dial tone 1B.
Type
Tone 1A/1B
Tone 2A/2B
54
Feature Manual
A normal dial tone is heard when:
a)
No features listed for dial tones 2 through 4 has been set, or
b)
Automatic Route Selection (ARS) is used.
This tone is heard when:
•
There are messages that have previously been listened to and no new
messages on the SVM card.*
•
Any of the features below are set.
•
Absent Message
•
BGM
•
Call Forwarding (FWD)
•
Call Pickup Deny
•
Call Waiting
•
Do Not Disturb (DND)
•
Extension Dial Lock
•
Executive Busy Override Deny
•
Hot Line
•
Timed Reminder
Description