Motorola DS3508 Manual page 30

Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
4 long low beeps
5 long low beeps
Fast warble beep
Low/high beeps
Host Specific
USB only
4 short high beeps
Low/medium/high beeps
upon scanning a USB device
type
Low/medium/high beeps
occur more than once
RS-232 only
1 short high beep
Bad symbology. Scanned a 1D or 2D bar code in a MPDF sequence, a duplicate
MPDF label, a label in an incorrect order, or trying to transmit an empty or illegal
MPDF field.
Flushing MPDF buffer.
Aborting MPDF sequence.
Flushing an already empty MPDF buffer.
The digital scanner has not completed initialization. Wait several seconds and
scan again.
Communication with the host must be established before the digital scanner can
operate at the highest power level.
The USB host can put the digital scanner in a state where power to the scanner is
cycled on and off more than once. This is normal and usually happens when the
PC cold boots.
A <BEL> character is received and Beep on <BEL> is enabled.
Indication
Scanning 2 - 3