Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
1. Mounting the change knob
Mount Spring (C) [46] and the Steel Ball D3.97 [47] into the Change Knob [45] as shown in the figure
below.
• Mounting the change knob
Steel Ball D3.97 [47]
Retaining Ring (E-Type)
for D5 Shaft [36]
2. Mounting the gear holder
Before mounting the Roller Holder [41], be sure to insert the Needle Roller [40] into the designated position
of the Gear Holder [35] because the Needle Roller [40] cannot be inserted after mounting the Roller Holder
[41].
• Mounting the gear holder
Gear Holder [35]
Reassembly
Spring (C) [46]
Change Knob [45]
Needle Roller [40]
Roller Holder [41]
-16-