Display - Kenwood TRC-80 Instruction Manual

DISPLAY
5 7
4
6 8
TUNE
I
S.CALL
I
MENU
EEl
LNB SCAN LOCK OUT
51 3 5 7 9 20 40 dB
H M L
RF 2 4 I 6 8 10
CD EEl
Appears while receiving with the squelch open.
m
Appears while transmitting or while the antenna tuner is
tuning.
NB
Appears while the Noise Blanker function is ON.
TUNE
Blinks while the antenna tuner is presetting or tuning.
Remains ON after a good match is obtained with the
antenna system.
SCAN
Appears while the Scan function is activated.
@ S.CALL
Appears while the Selective Call function is activated.
LOCK OUT
Appears when a channel is locked out from the Scan
function. These channels are not scanned.
@
MENU
Appears while the Menu system is being accessed.
@
88
Shows the selected channel number or, while accessing
the Menu mode, shows the selected Menu number.
Your Dealer may have programmed the radiotelephone
so as not to display channel numbers.
@ CH
Appears while the Channel mode is selected.
6
9
:11
JQ
@
IIIIIII
Shows the receive and transmit frequencies or
messages that are stored by your Dealer. The
messages may include alphanumeric characters,
spaces or symbols.
S1 3 5 7 SI 20 40 cS ...............
AF 2 .. e 8 10
While receiving, serves as an S-meter to display the
received signal strength. While transmitting, serves as
a relative transmit
RF
meter. While acting as an RF
meter, a full-scale indication corresponds to the
programmed maximum power.
@ H M L
One of these charactersappear as an indicationof the
transmit power level. The characters represent High,
Medium, and Low power respectively. If none of these
charactersare visible, either the maximum transmit
power is selected,or the Dealer has disabled this
character display.
@ CLARI
Appears while the CLARIFIER control is turned from its
detent
"0"position.
@ USB
Appears while Upper Sideband mode is selected.
@ LSB
Appears while Lower Sideband mode is selected.
@ AM
Appears while Amplitude Modulation mode is selected.
@ CW
Appears while ContinuousWave (Morse) mode is
selected.
@ DATA
Appears while Data mode is selected.