Initial Operation
cator
again (see fig. A). Therefore, regularly
20
check the water level on the water level indica-
tor
and replenish sufficient water in good
12
time!
ATTENTION! HAZARD OF BURNS!
Make sure that the water does not exceed the
MAX mark
. Otherwise, hot water may spurt
19
out of the steamer during operation.
Using Delay-Start Function
Note: Consider that the base of the appliance /
water tank
has to be filled with water at least
10
up to the MIN mark
. Ensure that the turbo ring
9
8
as well as the condensate collection basin
are positioned correctly.
Press the PROG button
, the time indicator
13
symbol
(see fig. A) will appear.
21
Press the PLUS / MINUS button
desired delay time in 10 minute steps each
time.
Note: The set delay time refers to the current
clock time. That means if you set a delay time
of 30 minutes at 13:00, the steaming process
will start at 13:30. The maximum delay time is
24 hours.
Press the PROG button
Press the PLUS / MINUS button
or reduce the steaming time in 5 minute steps.
Note: The maximum steaming time is 90 minutes.
Note: Be aware that you might have to replen-
ish water when the steaming time is longer.
Use the openings on the sides of the conden-
sate collection basin
of the appliance / water tank
the MAX mark
19
, it will be sufficient for approx.
1 hour of steaming.
Press the PROG button
display
the time indicator
13
PROG symbol
will appear. The delay-start
21
is now activated.
If the set delay time is elapsed, a signal tone
will sound, the pilot lamp
the appliance will start the steaming process
automatically.
10
GB/IE/CY
7
17
. In the LCD-display
as well as the PROG
20
16
to set the
17
again.
to increase
16
for refilling. If the base
7
10
is filled up to
17
again. In the LCD-
as well as the
20
will glow red and
15
ATTENTION! HAZARD OF BURNS!
The appliance will become hot during use.
Beware of getting in contact with the ascend-
ing steam or any components.
Note: If the supply of water is used up during
use, a signal tone will sound. The steaming
process gets stopped. Therefore, regularly
check the water level on the water level indica-
tor
and replenish sufficient water in good
12
time!
ATTENTION! HAZARD OF BURNS!
Make sure that the water does not exceed the
MAX mark
19
. Otherwise, hot water may spurt
out of the steamer during operation.
Press the PROG button
delay start. The PROG symbol
display
will go out.
13
Keep-Warm Mode
If the steaming time is elapsed, the appliance will
automatically switch over to keep-warm mode.
-
In the LCD-display
13
well as the keep-warm symbol
-
The pilot lamp
15
will glow green.
-
In keep-warm mode, the water is heated for
approx. 2 minutes, followed by a pause of
approx. 8 minutes without heating. In this way,
food is kept warm in the steamer at a tempera-
ture of 60 - 70°C.
ATTENTION! HAZARD OF BURNS! The
appliance will become hot during use. Beware
of getting in contact with the ascending steam
or any components.
-
The keep-warm mode will remain active until
the supply of water is used up.
Press the ON / OFF button
keep-warm mode.
Using Several Steam Trays
Place the largest food or this with the longest
steaming time (e.g. also rice) in the lower
steam tray
.
6
to terminate the
17
21
in the LCD-
the time indicator
20
as
will appear.
22
to terminate the
14