Assembling The Brake Shoe Plate - Yamaha XF50W Service Manual

REAR WHEEL AND BRAKE
3. Measure:
• brake drum inside diameter b
Out of specification
4. Check:
• brake drum inner surface
Oil deposits
Remove the oil with a rag soaked in lac-
quer thinner or solvent.
Scratches
Lightly and evenly polish the scratches
with an emery cloth.
5. Check:
• brake camshaft
Damage/wear
EAS00570

ASSEMBLING THE BRAKE SHOE PLATE

1. Install:
8brake camshaft 1
8o-rings
8brake shoe wear indicator 2
NOTE:
Lubricate the brake camshaft and o-rings with
lithium-soap-based grease.
w
After installing the brake camshaft and o-
rings, remove any excess grease.
• • • • • • • • • • • • • • • • • • • • • • •
a. Install the brake camshaft 1 so its punch
mark a is positioned as shown.
b. Align the projection b on the brake shoe
wear indicator with the notch in the brake
shoe camshaft.
c. Check that the brake shoes are properly
positioned.
• • • • • • • • • • • • • • • • • • • • • • •
2. Tighten:
8brake camshaft bolt
10Nm(1.0m
4-16
CHAS (3^3^)
-» Replace the wheel.
Brake drum inside diameter limit
(maximum)
110.5 mm(4.35 in)
-» Clean.
-» Repair.
-» Replace.
New
* kg, 7.2ft * lb)