Chapter 1 Pen Tablet Features; Pc Card Support; Internal Lan/Modem; Acpi Support - Fujitsu Stylistic 3500 Technical Reference Manual

Chapter 1
Pen Tablet Features
This chapter provides an introduction to the Stylistic 3500 pen tablet system hardware and gives an
overview of some of the pen tablet system's features. Detailed specifications on the features discussed in
this chapter are given in other chapters of this guide.
The Stylistic 3500 pen tablet computer is designed for the Windows 98 Second Edition, Windows NT
Workstation 4.0, and Windows 2000 Professional operating systems. The system uses an resistive pen
digitizer and is available with either an indoor color thin-film-transistor (TFT) display or an indoor/
outdoor color TFT display.
The Stylistic 3500 pen tablet system has been tested by Windows Hardware Quality Labs (WHQL) at
Microsoft Corporation and is compliant with PC 99 system design guidelines.

PC Card Support

The Stylistic 3500 pen tablet is equipped with a PC Card slot that allows you to install a Type II PC Card.
The PC Card slot is compliant with PC CardBus Standard Release 3.0 and provides support for the
following PC Card features:
• Multivoltage 3.3/5 V PC Cards (detected automatically)
• CardBus (PCI bridge) type PC Cards
• Supports PCIC (PC Card I/O Card) protocol
• Backward compatibility with previous PC Card Standard Release level PC Cards

Internal LAN/Modem

Stylistic 3500 pen tablet systems are equipped with an internal LAN/56 Kbps* modem. For details on the
built-in LAN/modem, see "Internal LAN/Modem Specifications" on page 44.

ACPI Support

The Stylistic 3500 pen tablet supports the Advanced Configuration and Power Interface (ACPI) Specification,
revision 1.0, in all system configurations except Windows NT 4.0; the Windows NT 4.0 operating system
does not utilize ACPI or APM design specifications.
* The 56 Kbps rate is nominal; due to FCC restrictions, actual rates are limited to 53 Kbps.
1
1
1
1