Panasonic AG-TL350B Operating Instructions Manual page 8

Parts And Their Functions
AC IN
4
1
Camera switching output connector
Camera switching output connector; connect it to
the frame switcher.
2
Audio input/output connectors
Audio input/output connectors (phono jacks)
3
Video input/output connectors
Video input/output connectors (BNC); connect the
input connector to the video camera, etc. and the
output connector to the TV monitor, etc.
4
AC IN connector
Connect the supplied power cord to an AC outlet.
5
Alarm input connector
Alarm recording input connector; connect it to the
external sensor.
6
COMMON terminal
7
Alarm reset input connector
Input connector for releasing alarm recording; a +4
to +14 V DC voltage is required.
8
REC IN connector
Input connector for recording
1 2 3
CAMERA
SW OUT
IN IN
AUDIO
VIDEO
OUT
OUT
ALARM RESET IN TAPE END OUT
GND
WARNING/
ALARM IN COMMON REC IN REC OUT
5 67 8 9 0 q w e
9
Tape end output connector
When the cassette tape comes to its end during
recording, the alarm device installed externally is
activated.
0
WARNING/REC output connector
When trouble has occurred in the unit, the alarm
device installed externally is activated.
Error warning or recording low signal selected on
the menu screen 3 is output.
q
GND Terminal
This terminal is connected to the signal ground
terminal of the connected unit in order to reduce
noise. It is not connected to ground for safety
purposes.
w
MIC input jack
Input jack (3 mm) for an external microphone.
This jack has precedence when signals are
supplied simultaneously to this jack and the audio
input connectors.
e
REMOTE control connector
For connecting the AG-A11 remote controller which
is available as an optional accessory.
r
Battery installation area
Install the battery in this area. See "Lithium Battery"
on page 3.
8
BATTERY
PUSH OPEN
MIC
REMOTE
r