Table of Contents
Advertisement
Table 1-7 Example of LED display
LED
Repeater status
display
Non-Priority
16.
Channel (ADD)
Non-Priority
16
Channel (DEL)
Priority Channel
.1
PC Programming
Mode
PC
PC Test Mode
PC Tuning Mode
P.G.
Firmware
Programming
PG.
Mode
PG
Un-Programmed E1
Channel data
E2
blank
PLL Un-Lock
E3
TX frequency
E4
data blank
Scanning Mode
SC
1.6.2
TX LED
Following are the conditions for the TX LED to light red:
•
TKR-750/850/751/851 is transmitting.
•
TKR-750/850/751/851 is sending data to PC during
FPU reading.
You can assign a function for switching the display On/Off
function to an auxiliary port and PF key.
Assignment, 18 Remote Control, 20 Function Port.)
Version: 1.01 USA
Description
DOT (.) appears on the right
side of the right digit.
-
DOT (.) appears on the right
side of the left digit.
"PC" appears automatically
after receiving PC command.
DOTs (.) appear on the right
side of left and right digits for
115200 bps data speed.
DOT (.) appears on the right
side of the right digit for
57600 bps data speed.
No DOT for 38400 bps data
speed.
This character appears when
all channels are blank.
This character appears when
the selected channel is
blank.
(In case of a blank channel is
selected in remote controller,
etc.)
TX PLL Un-Lock: TX LED
blinking.
RX PLL Un-Lock: BUSY LED
blinking.
This character appears when
attempting to transmit with a
channel which does not be
assigned a transmission
frequency.
(Valid for Repeater PTT, local
microphone PTT, external
PTT)
"SC" appear automatically.
(Refer to 15 Key
Function Reference (FUNC)
! Configuration of KPG-91D
" Configuring the function for switching On/Off the
display (Refer to FPRG 6.5 "Key Assignment"
window, 6.9 "Remote Control" window, and 6.10
"Function Port" window.)
1.6.3
BUSY LED
Following are the conditions for the BUSY LED to light
green:
•
TKR-750/850/751/851 is receiving a signal.
•
TKR-750/850/751/851 reads data by KPG-91D.
You can assign the function for switching the display On/
Off function to an auxiliary port and PF key.
Key Assignment, 18 Remote Control, 20 Function Port.)
! Configuration of KPG-91D
" Configuring the function for switching On/Off the
display (Refer to FPRG 6.5 "Key Assignment"
window, 6.9 "Remote Control" window, and 6.10
"Function Port" window.)
1.6.4
POWER LED
The LED lights green while TKR-750/850/751/851 is
using a main power and the LED lights red while using a
backup power.
Note: You must connect backup battery terminal with a backup
battery to use the backup power.
1.6.5
PF1 to PF6 keys LED
When functions are assigned to PF1 to PF6 keys and
pressed, the LED lights and the assigned function is
activated.
You can assign switching the display On/Off function to
auxiliary ports and PF keys.
18 Remote Control, 20 Function Port.)
! Configuration of KPG-91D
" Configuring the function for switching On/Off the
display (Refer to FPRG 6.5 "Key Assignment"
window, 6.9 "Remote Control" window, and 6.10
"Function Port" window.)
1 BASIC OPERATION
(Refer to 15
(Refer to 15 Key Assignment,
5
Advertisement
Table of Contents
