Bosch Integral TM13 Operating Instructions Manual page 138

If in doubt, look it up
The transmission parameters of both the sending and receiving terminal must be
properly defined for fault-free transmission. Various baud rates can be used if the
data flow is actively monitored. Please refer to the respective user manual for in-
formation on the configuration of your data terminal.
Clearing down data connections
Menu
Configuring the terminal adapter
Menu
Function
Testing the terminal adapter
Menu
Local test loop
138
You can clear down a data connection
manually via the keypad of your telephone
or via your data terminal.
Clear down via your phone:
Select the menu item "TA dialing" to display
'TA dialingµ
information about your data connection.
Press the "Release" key.
The data connection is terminated.
Clear down via your data terminal:
The setting "DTR" must be selected from
the menu item "Disconnect".
'Set TAµ Select the menu item "Set TA". This menu
contains all of the parameters that you can
modify.
Define the parameters for your terminal.
Some parameters cannot be modified. Fur-
'TA-V.24
ther information on the individual parame-
ters may be found in the terminal adapter
user manual.
Note:
You may only change the parameters of
your terminal adapter if there is no ongoing
data connection.
'Test TA Select the menu item "Test TA".
You can now perform various tests.
off Note:
To display the state of the V.24 interface
circuits, press the "Arrow down" key sev-
eral times until the status appears on the
display.
Terminal adapter A