Connecting Peripheral Equipment - Sharp PN-655E Operation Manual

Connecting Peripheral Equipment

This section describes the terminals of the monitor.
Be sure to set the main power switch to "OFF (O)" (see page 21) and disconnect the plug from the
power outlet (see page 17) before connecting or disconnecting the cables.
Digital connection with a PC (Input mode: DIGITAL)
A PC image can be displayed using the PC digital RGB (DVI-D) input terminal.
• Connect to the digital RGB output terminal on your PC using a digital signal (DVI) cable
(commercially available).
* Connection with computers that have an output terminal (DVI-D 24 pin or DVI-I 29 pin) conforming to DVI is
possible. (However, images may not display properly depending on the computer.)
• Connect with an audio output terminal on your computer using a PC audio cable (commercially
available).
• Select the input mode "DIGITAL" for this connection. (See page 22.)
Output terminals on
connected equipment
Audio Digital RGB
• See page 56 for compatible signal timing.
12
E
Digital signal (DVI) cable (commercially available)
PC audio cable (commercially available)
Rear view
PC digital RGB input terminal
PC audio input terminal