Notice To Users - Toshiba e-Studio 232 Operator's Manual

Notice to Users

After a suitable place has been selected for the installation of the e-STUDIO232/282 or e-STUDIO233/
283, please do not change it. Avoid excessive heat, dust, vibration and direct sunlight. Also, provide
proper ventilation as the copier emits a small amount of ozone.
The unit is classified as Class 1 Laser Product according to IEC 60825-1:1993/EN 60825-1.1994 includ-
ing amendments.
The unit uses laser diode of output 5 mW, wave length 785 nm, continuous pulse.
Caution:
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Warning:
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Working environment
From EMC (Electromagnetic Compatibility) point of view, the operation of this product is being restricted
in following environments:
* Medical Environments: This product is not certified as a medical product according to the Medical
Product Directive 93/42/EEC.
* Domestic environments (e.g. a private living room with TV / Radio sets in the nearby surrounding
area) because this is a so called EMC class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take adequate measures!
Any consequences resulting from the use of this product in restricted working environments are not the
responsibility of TOSHIBA TEC.
The consequences of the use of this product in restricted non-approved working environments may be
an electromagnetic interference with other devices or machines in the nearby surrounding area. This
can result into malfunction including data loss / data error pertaining to, this product or the other devices
/ machines involved in the electromagnetic interference.
Therefore Toshiba strongly recommends that the electromagnetic compatibility of this product be suit-
ably tested in all non-approved working environments before use. In the case of automobiles or aircraft,
the manufacturer or airline respectively should be asked for permission before use of this product.
Furthermore, for general safety reasons, the use of this product in environments with explosive atmo-
spheres is not permitted.
CE compliance
This product is labelled with the CE mark in accordance with the provisions of the applicable European
Directives, notably the Low Voltage Directive 2006/95/EC, the Electromagnetic Compatibility Directive
2004/108/EC for this product and the electric accessories, the Radio Equipment and Telecommunica-
tions Terminal Equipment Directive 1999/5/EC for the telecommunication accessories.
CE marking is the responsibility of TOSHIBA TEC GERMANY IMAGING SYSTEMS GmbH, Carl-
Schurz-Str. 7, 41460 Neuss, Germany, phone +49-(0)-2131-1245-0.
For a copy of the related CE Declaration of Conformity, please contact your dealer or TOSHIBA TEC.
For Germany only
Machine Noise Information
Ordinance 3. GPSGV: The maximum sound pressure level is equal or less than 70 dB(A) according to
EN ISO 7779
5