HP f150 User Manual page 8

Cloud Mode (stream to Internet)
Before using Internet Cloud Mode, you must setup your f150 camera.
You must enter your wireless network and Ustream (Cloud AP/Cloud
Service) parameters into the camera using HP Ucam. To do so, c
to your f150 using Direct Mode (see page 4).
• Start HP Ucam. Go to setup. Scroll down to "Cloud Setting."
1. Select the preferred WiFi network you wish to use and enter
its WiFi password, if any. This step enables the f150 camera to
get on the local WiFi wireless network for Internet access.
Next, you must enter
• Press then enter your Username (and/or email address)
and password for the Cloud AP you wish to use, such as Ustream.
When completed press [Save to Camera]. This will store your WiFi
and Cloud AP information to the camera.
Once you have setup your camera there are two ways to connect
it to a Cloud server:
1. Power on the camera. It will go to Direct Mode. Connect
your mobile to the f150 in Direct Mode. Start HP Ucam. Press
on Setup. Press [Camera to Cloud]. The camera will switch from
Direct Mode to Clous Mode for live streaming to the Cloud.
2. Power on the camera. Press the mode button to select Cloud
mode. The Cloud LED will flash red while connecting to the Cloud.
When the camera has sucessfully connected to the Cloud, the LED
will flash green, slowly. If the connection is unsucessful the Cloud
LED will flash fast-red. In that case, check your Cloud AP settings
Once your camera is connected to the Cloud you may view
your Live Video
your Cloud Server (Ustream) information.
at: www.ustream.tv
onnect
English | 5