Fast Guide To The Special Functions - Electrolux ERF2000 Service Manual

In the table below are described, shortly, all the special functions for the user and the Service technicians.
Starting
Function
conditions
Temperature field
Appliance
variation of the
connected and
freezer
ON
(Sweden models)
EEPROM Error
Appliance ON
Disconnect
EEPROM Code
Software version and reconnect
Fault code
the appliance
Disconnect
LEDs controls
and reconnect
and loads
the appliance
Compartment
internal
Demo
temperature
Mode
higher than
10°C
ERF2000 Functions of the electronic boards

7.5 Fast guide to the special functions

Function
Function activation
interruption
Buttons
Super Temperature
decrease
+ Appliance ON
Temperature increase
for 5 sec
ON
Appliance ON
Super button within
one minute
At the end of
Temperature decrease the procedure it
for 5 sec. within 15 returns
sec after reconnection automatically to
of the appliance a normal
condition
Temperature increase Programme
for 5 sec. Within 15 interrupted
sec after reconnection automatically
of the appliance after 1 min.
Disconnect the
Temperature decrease
appliance or
+
repeat the
On/Off button
operation of
for 5 sec
activation
Short description / Notes
After 5 sec the buzzer sounds with a long signal confirming that temperature is
decreasing.
By repeating the operation the buzzer sounds with a short signal and resets at
the starting conditions.
If an EEPROM error has occurred the buzzer sounds with a long signal;
The display switches off, the buzzer sounds with a long signal; the display
shows 4 digits of EEPROM code alternated by a short signal; the last digit is
not followed by a short signal: the display switches off, the buzzer sounds with
a long signal; the display shows digits/letters of the software version code
alternated by a short signal of the buzzer: the last digit is not followed by a
short signal; the display switches off, the buzzer sounds with a long signal; the
display shows letter E; then the buzzer sounds with a short signal and fault
code appears; the display switches off and buzzer sounds with a long signal.
The buzzer sounds with a long signal, all LEDs and digits of the display board
are on; all the loads of the power board are on; by opening the door alarm LED
switches off (for the 4 star appliances the led Super switches off); when an
alarm button is pressed it sounds, and if the evaporator sensor is featured, the
evaporator temperature is displayed.
The display board is on; refrigerator compartment display shows +5°C and
freezer compartment -18°C at low frequency; by opening the door the light
switches on; compressor always Off
27/30