Kenmore 592-89032 Use & Care Manual page 17

Temp Selection Button
To select the correct temperature for the load, press the Temp button.
An indicator light will illuminate next to the desired temperature. Press
the button repeatedly to scroll through the settings.
■ High - For sturdy cottons or those labeled Tumble Dry.
■ Medium - For permanent press, synthetics, lightweight
cottons, or items labeled Tumble Dry Medium.
■ Med Low - For lower heat than Medium to dry synthetic or
washable knit fabrics.
■ Low - For heat sensitive items labeled Tumble Dry Low or
Tumble Dry Warm.
■ Extra Low - Provides the lowest heated dry temperature possible.
Time Selection Button
When using Manual Dry cycles, time can be adjusted by
pressing the time selection button.
During the Sensory Dry cycle, the time light indicator is off
because exact drying times are determined by fluctuating
humidity levels.
Signal Selection Button
When the cycle is complete, a chime will sound.
When the Wrinkle Guard option is selected, the chime will sound
intermittently. Adjust the volume of the chime or turn it off by
pressing the Signal button.
Press the button repeatedly to scroll through the choices.
Rack Dry
Rack Dry is available at Time Dry cycle. Temperature will be set
only to Extra Low. (See next page for detail.)
When the cycle is complete, a chime will sound.
When the Wrinkle Guard option is selected, the chime will sound
intermittently.
Wrinkle Guard
Wrinkle Guard provides approximately 90 minutes of intermittent
tumbling in unheated air at the end of the cycle to reduce
wrinkling. Press the Wrinkle Guard button to activate this feature.
The indicator light above the pad will illuminate when Wrinkle
Guard is selected.
The load is dry, and can be removed at any time during the
Wrinkle Guard cycle.
>%(67@  $B(1BYLQGG 
My Cycle
Choose your favorite cycle including cycle, temp, dry level
option, etc.
Lets you activate your customized cycle that includes Dry Level,
Temp etc.
By pushing the My Cycle button, you activate the settings used
during the previous My Cycle mode.
If My Cycle mode is activated, the My Cycle indicator will be lit.
You can select all options in My Cycle mode as follows.
1. Select cycle using the Cycle Selector dial.
2. After cycle selection, set each option of your choice.
3. Then, you can start My Cycle by pushing the Start/Pause
button in My Cycle mode. The cycle and options you select
will be displayed the next time you choose My Cycle.
(You can change the My Cycle settings by repeating the
same process above. The last used setting will be displayed
the next time you choose My Cycle.)
4. If you want to deactivate My Cycle, simply push the My
Cycle button again. But after deactivating My Cycle, the
previously chosen setting will be displayed again by default.
■ Each cycle has certain default options that are automatically set.
To see these default options, go to page 21.
Adjust Time
Time can be added or subtracted from the automatically set
times in the Manual Dry cycles (Time Dry, Air Fluff cycles).
To add or subtract time from the cycle, press the Adjust Time
arrow pad up or down until the desired time is displayed.
Mixed Load Bell
This is an alarm that notifies the user when the average
dry level is damp dry (80% dried). This is useful when the
laundry contains various types of clothing you do not want
to dry completely. An alarm sounds for five (5) seconds while
continuing to perform the cycle.
This function can only be selected in the Sensor Dry course, and
the dry level can only be selected from among Normal Dry, More
Dry, and Very Dry.
Start/Pause selection Button
Press to pause and restart programs.
17