ENGLISH (Original instructions) SPECIFICATIONS Model WT01 Standard bolt M8 - M12 (5/16" - 1/2") Capacities High tensile bolt M6 - M10 (1/4" - 3/8") Square drive 9.5 mm (3/8") No load speed (RPM) 0 -2,300/min. Impacts per minute 0 - 3,000 Max.
Page 3
turning the power tool on. A wrench or a key left when used with another battery pack. attached to a rotating part of the power tool may 25. Use power tools only with specifically result in personal injury. designated battery packs. Use of any other 14.
injury. Tips for maintaining maximum battery life USD302-1 Charge the battery cartridge before completely Symbols discharged. Always stop tool operation and charge the The followings show the symbols used for tool. battery cartridge when you notice less tool ¥ volts power.
Page 5
• consistently fails to quickly stop after switch trigger to a complete stop. Changing the direction of release, have tool serviced at a Makita service center. rotation before the tool stops may damage the tool. Turning on the front lamp When not operating the tool, always set the •...
without applying excessive pressure on the tool. OPERATION Excessive fastening torque may damage the • bolt/nut or socket. Before starting your job, always perform a test operation to determine the proper fastening time for your bolt or nut. Especially for the bolt smaller than M8 (5/16"), perform the above test operation to prevent the trouble on socket or bolt, etc.
COMPLETE tool, freight prepaid, to one of Makita's Factory or Authorized Service Centers. If inspection shows the trouble is caused by defective workmanship or material, Makita will repair (or at our option, replace) without charge. This Warranty does not apply where:...
Page 8
Para reducir la exposicion a estos productos quimicos: trabaje en un area bien ventilada, y pongase el equipo de seguridad indicado, tal como esas mascaras contra el polvo que estan especialmente disenadas para filtrar particulas microscopicas. Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan www.makita.com...