Control Panel
To remove the control panel:
1. Open the compactor drawer. Turn the knob to
the off position and remove it by pulling straight
out.
2. Remove the 2 Phillips-head screws from the
knob recess.
3.
Insert a small-bladed screwdriver between the top
of the control panel and the front cover.
4.
Pry the control panel forward and release it
from the 3 top tabs.
5.
Lift the control panel from the 3 bottom tabs.
Built-In Compactor Components
Switch Bracket
To remove the switch bracket:
1.
Disconnect power.
2.
Remove the control panel. (See
3.
Remove the 3 Phillips-head screws that attach
the switch bracket to the frame.
4.
Raise the switch wiring harness parallel to the
bottom of the switch bracket.
Switch Wire
Harness
5.
Pull the bottom of the switch bracket out to
clear the bottom of the front cover opening.
Rotate it approximately 45° counterclockwise
then remove the switch bracket from the front
cover opening.
– 13 –
.)
Control Panel
Switch Bracket
(Continued next page)