Using External Antennas; Plugging In The Receiver - Pioneer HTP-071 Operating Instructions Manual

02 Connecting your equipment
02

Using external antennas

To improve FM reception
Use a PAL connector (not supplied) to connect an external
FM antenna.
ANTENNA
FM
UNBAL
75
To improve AM reception
Connect a 5 m to 6 m (16 ft. to 20 ft.) length of vinyl-coated
wire to the AM antenna terminal without disconnecting the
supplied AM loop antenna.
For the best possible reception, suspend horizontally
outdoors.
Outdoor
antenna
5 m to 6 m
Indoor antenna
(16 ft. to 20 ft.)
(vinyl-coated wire)
16
En

Plugging in the receiver

Only plug in after you have connected all your components to
this receiver, including the speakers.
CAUTION
• Handle the power cord by the plug part. Do not pull out
the plug by tugging the cord, and never touch the power
cord when your hands are wet, as this could cause a short
circuit or electric shock. Do not place the unit, a piece of
furniture, or other object on the power cord or pinch the
cord in any other way. Never make a knot in the cord or tie
it with other cables. The power cords should be routed so
that they are not likely to be stepped on. A damaged
power cord can cause a fire or give you an electric shock.
F connector
Check the power cord once in a while. If you find it
damaged, ask your nearest Pioneer authorized
independent service company for a replacement.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular use,
e.g., when on vacation.
Note
• After this receiver is connected to an AC outlet, a 2
second to 10 second HDMI initialization process begins.
You cannot carry out any operations during this process.
The HDMI indicator in the front panel display blinks
during this process, and you can turn on this receiver
once it has stopped blinking.
1 Plug the AC power cord into a convenient AC power
ANTENNA
outlet.
AM LOOP