Samsung HG690 Installation Manual page 70

Launching Ventus application
Go to File Menu
Upgrading the clone or binary file on TV
To upgrade the clone for binary file on the TV, use a prepared merged stream (Binary_outputstream.mpg or clone_
outputstream.mpg).
1. Locate the stream file in the Modulator utility ( as explained in 2.11).
2. Set the set channel to broadcast the stream by clicking on Frequency Table.
3. Select Opencable for ATSC or DVB-C for DVB models.
4. Click Play to broadcast the stream.
5. In TV's factory menu, the SIRCH channel must be same as the channel on which stream is broadcasting.
6. The SIRCH version must be earlier than the software version set before generating the stream file.
7. Click on Manual SIRCH. Please check taht the channel setup is set to Cable, not Air, if the cable is connected
to TV for broadcasting.
Updating the application with new Model
To update the application with a new model, to configure the clone files for that model, users must possess a model
installation XML file. To update a new mode, follow these steps:
1. Go to File Menu
2. A window (Add/Update Model) opens and asks users to enter
the Configuration file (Model installation xml file). Click the
Browse button to locate the model installation xml file.
3. After selecting the installation file, the window shows the model
name, series, region and TV model name in extboxes.
4. To add model click the Add button. If a model already exists,
application will update the model orl add the model in the
model dropdown box.
5. To close the window click Close button.
70
English
[HG690_EURO]Install_Guide-00ENG.indd 70
Utility Generate and click GO for Launch Ventus
Update New Model.
2013-03-21 4:37:04