Transferring A Call After A Speaker Call Announcement In A Group; Send Trunk Flash (Not For Hipath 500) - Siemens HiPath 500 User Manual

Enhanced phone functions
Step by Step
)80
)51
40
Transferring a call after a speaker call
announcement in a group
If this function has been configured (contact your ser-
vice personnel), you can use a speaker call (announce-
ment, page 62) to announce a call in progress to a
group of users
After a member of the group has accepted the call re-
quest, you can transfer the waiting party.
Prerequisite: You are conducting a call.
S
Press the "Consult" key. The LED flashes.
Enter the code.
j
Enter the group's station number.
[
Announce the call.
You are connected to a member of the group when this
party accepts the call.
\
Replace the handset.
If the connection between the two other parties
is not established within 45 seconds, the call
from the first part returns to you (recall).

Send trunk flash (not for HiPath 500)

To activate ISDN-type services and features through the
network carrier's analog trunks or those of other com-
munications platforms (such as "consultation hold"), you
must send a signal to the trunks before dialing the ser-
vice code or telephone number.
Prerequisite: You have set up an external connection
via an analog line.
S
Press the "Consult" key. The LED flashes.
Enter the code.
j
Enter the service code and/or telephone number.
page 31.