Sony 600TVL O.S.D. WDR SERIES Service Manual page 11

Daytime setting:
Adjust the lens focus to see a clear image both at the center and the upper /
down edges of the monitor. If the image on the monitor is too bright, adjust
the shutter speed accordingly.
Enter EXPOSURE sub-menu under SETUP menu and select "SHUTTER".
Select shutter speed according to the speed of vehicle.
Suggested Shutter Speed:
When speed of vehicle is less than 50km: 1/250 sec.
When speed of vehicle is less than 100km: 1/500 sec.
When speed of vehicle is more than 100km: 1/2000 sec.
Nighttime setting:
Adjust the lens focus to see a clear image at the upper / down edges of the
monitor (means focus at the center). According to the environment, adjust
AGC value to heighten the brightness signal when necessary.
Enter EXPOSURE sub-menu under SETUP menu and select "AGC".
AGC: LOW – MIDDLE – HIGH adjustable.
5. If the image is smeared and the license plate number is not captured clearly:
When the camera is connected directly to the monitor: Adjust the shutter
speed until the image is clear.
When the camera is connected to a DVR system: If you get a smeared image
during playback, the reason is the performance of VGA card in the DVR is
not sufficient.
NTSC PAL
1/60 1/50
1/250 1/250
1/500 1/500
1/1000 1/1000
1/2000 1/2000
1/4000 1/4000
1/5000 1/5000
1/10000 1/10000
1/100000 1/100000
V.4B_W_M