Kenwood SC5000 Instruction Manual page 3

PLEASE READ THESE INSTRUCTIONS CAREFULLY
Before using the appliance read the instructions carefully.
"
NEVER ADD DECALCIFICATION, AROMATIC, ALCOHOLIC OR DETERGENT PRODUCTS
"
INTO THE APPLIANCE, AS THIS MAY DAMAGE IT OR MAKE IT UNSAFE FOR USE.
The appliance is equipped with a thermostat that limits temperature, a thermofuse and a safety cap.
"
Before connecting the appliance to the power supply make sure that the voltage shown on its label
"
corresponds to that in the local power supply source.
Always connect the appliance to an earthed socket.
"
Never leave the appliance unattended when still connected to the power supply source.
"
Do not turn over the appliance when in operation.
"
Do not immerse the appliance in water or other liquids.
"
Always unplug the Steam Mop from the power supply socket when filling with water.
"
ATTENTION! When the appliance is first filled, small quantities of water may pour out of the tank. This
"
is normal and will no longer occur when the tank is refilled.
The appliance is not intended for use by young children or infirm persons without supervision.
"
Young children should be supervised to ensure that they do not play with the appliance.
"
Do not touch its hot surfaces. Avoid directing steam towards people and electrical equipment.
"
Do not use the appliance if it appears damaged. All repairs, including changing of the power cable
"
must be carried out exclusively by the KENWOOD Service centre or KENWOOD authorised Service
Agents.
This product has been made for domestic use and not for industrial or commercial.
"
Your KENWOOD STEAM MOP is ideal for ceramic, marble, vinyl, stone, linoleum and sealed hardwood
"
floors. Please see special note below on wooden floors. The Mop produces heat and steam similar to a
steam iron and can reach temperatures in excess of 95°C. Therefore DO NOT leave in one spot during
use or while hot for more than 15 seconds.
Timber Flooring.
"
Before using on any Timber surface we recommend that you trial a small inconspicuous
area first to check that the steam has not damaged the sealant or protective surface
coating. If the decision is made to continue use on the timber floor care must be taken
in traffic areas where the protective coating maybe worn down. Steam may penetra
te and damage the wood.
Flooring that has been treated with wax, the wax may be removed by the heat and steam
action leaving the surface dull.
Do not use on unsealed wood floors or let unit stand on any wood floor for an exten
ded period of time. This could cause the wood grain to rise.
Also check use and care instructions from the floor manufacturer.
Not recommended for use on CORK or CORK tiles.
"
Kenwood will not accept any responsibility for damage caused to flooring if the above warnings has
"
been ignored.
IMPORTANT INFORMATION