Leveling The Wall Oven - Kenmore ELECTRIC WALL OVEN Installation Instructions Manual

KENMORE ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
6 Install the Anti-tip Mounting Screws
The wall oven can tip when the door
is open. The anti-tip mounting screws supplied
with the wall oven must be installed to prevent
tipping of the wall oven and injury to persons.
A. The mounting holes in the side trims may be used
as a template to locate the appliance mounting screw
holes (see figure 6).
B. Use the two screws supplied to fix the appliance to
the cabinet.
Select Timer
Clean Set/Off
Anti-tip
Mounting Screws
Figure 6
7 Install the Bottom Trim
Place the top of the bottom trim over the side trim tabs
on each side of the oven below the oven door and fix
it using the 2 screws supplied in the mounting holes
located on each side trim below the oven frame (see
Figure 7).
NOTE:
For the double wall ovens only: If the cutout
height is between 51 /
13
16
(131.9 cm) use the larger bottom trim.
Screws
supplied
Figure 7
(and Optional Electric or Gas Cooktop Combination)
Cook Add 1 Bake Bake Broil
Time Minute
Delay Oven STOP Warm &
Start Hold
Clear
Preheat
Oven
Door Locked 3 Lockout
" (131.6 cm) and 51 / "
15
16
Bottom Trim

6. Leveling the Wall Oven

1. Install an oven rack in the center of the upper oven
(see Figure 8).
2. Place a level on the rack. Take 2 readings with the
level placed diagonally in one direction and then the
other. Use wood shims under the wall oven to level if
necessary.
3. Repeat in the lower oven if you have a double cavity
wall oven. If the level indicates that the rack is not
level, use wood shims to reach a compromise for
both ovens.
IMPORTANT NOTE
A cooling fan inside the upper rear part
above the oven (some models) provides
cooling of the oven electrical and
electronic components. If the oven has
been operating at high temperatures, the
fan will continue to run after the oven is
turned off.
6
Figure 8