Husqvarna Rider Pro 15 Operator's Manual page 21

Maintenance
Lubricate throttle control
Lubricate choke control
Smörj styrkedja i ramtunnel.
Lubricate steering chain inside frame
tunnel
Clean engine cooling air intake
Clean the air filter pre-filter (oil-foam)
Change engine oil
Clean the air filter cartridge
Check/adjust cutting height setting
Check/adjust parking brake
Inspect flame guard/spark arrestor
(optional equipment)
Replace the engine oil filter
(every 200 hours)
Clean/replace spark plugs
Replace fuel filter in pipe
Clean pulse-air filter
Clean the cooling flanges
Check engine valve clearance
Check whether oil change
necessary for K62 gearbox
(every 500 hrs)
Replace the air filter pre-filter (oil-foam)
Replace the air filter (paper filter)
(every 200 hours)
Carry out 300 hour service
1)
First change after 5 hours.
every 25 hours if pre-filter is not fitted. Clean and replace the filter more often in dusty conditions.
lubrication should be conducted twice a week.
= Described in these instructions.
= Not described in these instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed
from the plugs.
20
– English
MAINTENANCE
1)
2)
(paper filter)
4)
4) are
2)
2)
4)
2)
When driving with a heavy load or when the ambient temperature is high, replace every 25 hours. Clean
4)
Conducted by authorised service workshop.
Page Daily main-
Weekly
tenance
main-
before after
tenance
44
44
43
22
26
27
45
25
31
23
-
47
-
24
26
-
-
-
25
25
-
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance interval in
At least
3)
hours
once a
year
25 50
3)
For daily use of the machine
100 300