Rs-232C Command Table - Sharp PN-K322B Operation Manual

RS-232C command table

How to read the command table
Command: Command field (See page 27.)
Direction: W When the "Parameter" is set in the parameter field (See page 27.), the command functions as described
under "Control/Response Contents".
R The returned value indicated under "Reply" can be obtained by setting "????" or "
parameter field. (See page 27.)
Parameter: Parameter field (See page 27.)
Reply: Response (Returned value)
*: "●" indicates a command which can be used in power standby mode.
"–" indicates a command which cannot be used in power standby mode.
Power control/Input mode selection
Function
POWER CONTROL
INPUT MODE SELECTION
TOUCH ACTION MODES
Command Direction Parameter
POWR W 0
1
R
INPS W 0
9
10
12
13
14
15
R
TCMD WR 0-2
Controlling the Monitor with a PC (RS-232C)
Reply Control/Response contents
Switches to standby mode.
Returns from standby mode.
0 Standby mode
1 Normal mode
2 Input signal waiting mode
Toggle change for input mode. Terminals not selected in INPUT SELECT cannot
be selected.
HDMI1 [AV]
"ERR" when PC is selected for HDMI1 of INPUT SELECT.
HDMI1 [PC]
"ERR" when AV is selected for HDMI1 of INPUT SELECT.
HDMI2 [AV]
"ERR" when PC is selected for HDMI2 of INPUT SELECT.
HDMI2 [PC]
"ERR" when AV is selected for HDMI2 of INPUT SELECT.
DisplayPort
HDMI DUAL
9 HDMI1 [AV]
10 HDMI1 [PC]
12 HDMI2 [AV]
13 HDMI2 [PC]
14 DisplayPort
15 HDMI DUAL
0-2 0: Finger/pen mode, 1: Pen-only mode, 2: Finger-only mode
?" in the
*
●
●
●
-
29
E