Operations
Built-in Viewer Operations
(continued)
Unicast Setting (continued)
A
HTTP Port
B
JPEG Frame
Rate
98
You can change the port number to be used when the client PC accesses to the
camera via HTTP.
Specify the same value as the parameter being set on the camera's Protocol
Page. (A Page 54)
[Factory default: 80]
Sets a frame rate for image acquisition by the viewer.
A high frame rate increases the amount of data processed by the PC where the
viewer is running.
[Set values: 30 fps, 15 fps, 10 fps, 7.5 fps, 6 fps, 5 fps, 3 fps, 2 fps, 1 fps,
1/2 fps, 1/3 fps, 1/5 fps, 1/10 fps, 1/15 fps,1/20 fps, 1/30 fps,
1/60 fps]
Memo:
● Set the JPEG frame rate so that the CPU load of the PC does not exceed
80%. If the CPU load is too high, the PC may not operate normally.
● The highest frame rate for images is the camera's encoding setting (A Page
24, Framerate value).