Maintenance; Maintenance Schedule - Husqvarna 1030 BioClip Operator's Manual

The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.

Maintenance

Check the engine's oil level
Check the engine's cooling air inlet
Check the fuel pump's air filter
Check the transmission's air inlet
Check the transmission's oil level
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check screws and nuts
Check for fuel and oil leakage
Clean the air filter's pre-filter (foam plastic)
Check the cutting unit
Check the tyre pressures (60 kPa)
Adjust the brakes
Check the V-belts
Change the engine oil
Lubricate joints and shafts
Check and adjust the throttle wire
Replace the air filter's pre-filter and paper filter
Replace the oil filter
Replace the fuel filter
Replace the plugs
Clean the engine's and the hydrostat's cooling flanges
Check the valve clearance
Check the valves and seats
1)
First change after 8 hours.
machine lubrication should be conducted twice a week.
= Described in these instructions.
= Not described in these instructions.
!
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed from the plugs.
MAINTENANCE

Maintenance schedule

2)
1)
3)
4)
4)
2)
During dusty conditions cleaning and replacement should be more frequent.
4)
Page
tenance
before start
19
19
19
20
20
21
22
22
22
–
–
23
24
30
22
–
27
28
29
2) 23
28
30
–
2,4)
–
–
–
Conducted by authorised service workshop.
•
•
Daily
Maintenance interval
main-
in hours
25 50
3)
For daily use of the
The parking brake is applied.
The cutting unit is disengaged.
100
300
17
English –