LG LE3116D Owner's Manual page 56

Camera Setting
1. Select a channel for settings.
If you want to block a channel from other users,
mark up the convert option. The marked up chan-
nels are displayed "LG logo" on the live windows
for POWER or NORMAL user.
2. Enter the new channel name.
3. Select input audio channel.
4. Set the PTZ control options.
• Port: Select the connected data port of the
RS-422/485 terminal on the rear panel.
• Control ID: Select the PTZ camera ID from
0 to 255. Make the same settings as the PTZ
camera.
• Protocol: Select the protocol supported by
PTZ camera.
• Baud Rate: Select the communication
speed.(1200, 2400,4800,9600,19200 or
38400)
5. Set the motion options.
• Sensitivity: Set the sensitivity level for the
created motion detection area. Sensitivity can
be set from 0 to 10.
• Alarm Out: Select the number of the
ALARM-OUT terminal for the output alarm
signal when motion is detected.
• Area: Select the desired motion detection
area on the preview window screen using the
mouse. Click the one point and drag & drop
the end point to select the motion area.
Notes:
• If you want to display the grid, mark up the [Show
Grid] option.
• If you want to select the entire area, click the [Set
All] button or click the [Clear All] button to cancel
the selected area.
56
Recording Frame Rate Settings
1. Click the [Frame Rate Settings] button.
The recording frame rate settings window
appears.
2. Set each options using the mouse.
• Resolution: Select the recording resolution.
(NTSC: 352*240, 704*240 or 704*480
PAL: 352*288, 704*288 or 704*576)
• Quality: Select the recording picture quality.
(Lowest, Low, Standard, High or Highest)
• Frame Rate: Select the frame rate. The frame
rate is the number of recorded frames in a
second. According to resolution, the frame
rate is set automatically. If you set manually,
refer below.
Resolution
NTSC 352*240 1, 3, 5, 7.5, 15, 20, 30
704*240 1, 3, 5, 7.5, 15
704*480 1, 3, 5, 7.5
PAL 352*288 1, 3, 5, 6, 12.5, 20, 25
704*288 1, 3, 5, 6, 12.5
704*576 1, 3, 5, 6
• Pre-Alarm Time: Specify the pre-event
recording time to records the situation until the
sensor alarm signal has input or motion has
been detected. (Off, 5, 10, 20, 30, 40, 50, 60
Sec)
• Post-Alarm Time: Specify the post-event
recording time that records the situation after
the sensor alarm signal has input or motion
has been detected. (10, 20, 30, 40, 50 Sec or
1, 2, 3, 5, 10 Min)
3. Click the [Ok] button to confirm the settings.
Frame Rate