D-Link DVG-7022S User Manual page 34

DVG-7022S/7044S/7062 User's Manual
Put Caller ID In URI: This feature is to put Caller ID in URL. The Caller ID is located in SIP →
Message Header → After [From:], Before [<sip:] by default settings. It will be located in SIP →
Message Header → After [<sip:], Before [@]if ticked.
INVITE With Remote-Party-ID Header: Check the box to comprise the information of
Remote-Party-ID in the message header of INVITE. Different format of INVITE header might cause the
call not to be connected. Please consult with your VoIP Service Provider before enabling it.
Support URI Percent-Encoding(RFC 3986): It follows RFC 3986 to encode/decode the letters of the
basic Latin alphabet, digits, and a few special characters.
Compare SIP 'To' Header for Transit Out: When FXO is called and the number of Request line and
"To" is different, the system will use the number of "To" to dial out. Please consult your Proxy Server
Provider or ITSP about the format of invite packet from Proxy.
Enable SIP 'Allow' Header: Check the box to comprise the information of "Allow" in the message
header of INVITE. Disable it if the call can't be connected.
Call Hold Compatible With RFC 2543: Check the box to comprise c=0.0.0.0 in SDP message to be
compatible with RFC2543.
E.164
International Call Prefix Digit: Enter the International call prefix.
Country Code: Users please select the desired country code.
Long Distance Call Prefix Digit: The long-distance prefix digit for making a long-distance call.
Area Code: Please enter the area code.
E.164 Numbering: This variable invites the proxy to follow the E.164 rule, but it depends on the proxy.
If you fail to make a call, please contact your ITSP.
NOTE: All settings in this section are specific to your VoIP network. Please ask your VoIP service
provider whether or not they require these settings.
D-Link Systems, Inc.
SIP
30