Epson Viewer P-2000 User Manual page 12

❏
If you plan to use this product in Germany, the
building installation must be protected by a 16
amp circuit breaker to provide adequate
short-circuit protection and over-current
protection for this product.
❏
Do not use a damaged or frayed AC adapter.
❏
If you use an extension cord with this product,
make sure the total amperage of all devices
plugged into the extension cord does not exceed
the cord's amperage rating.
❏
Never disassemble, modify, or attempt to repair
the AC adapter by yourself except as specifically
explained in this guide.
❏
Do not use power outlets controlled by wall
switches or automatic timers.
❏
Do not use power outlets on the same circuit as
large motors or other appliances that may cause
voltage fluctuations.
❏
Avoid using outlets on the same circuit as
photocopies or air control systems that regularly
switch on and off.
6
Introduction
❏
To prevent fire or electric shock, do not cover the
AC adapter with a blanket or similar covering.
❏
Position this product's power cord so that it will
not be stepped on or run over.
❏
Do not place any objects on the power cord and
the AC adapter.
❏
Keep the power cord straight at the ends and at
the points where it enters the transformer.
❏
The power cord should be placed to avoid
abrasions, cuts, fraying, crimping, kinking, and
other damage.
❏
If the AC plug does not fit your outlet, have a
proper outlet installed by a qualified electrician.
❏
Remove the AC plug from the outlet during
lightning storms.
For US and Canadian users:
Use the included power cord or a 6 to 10 foot
UL-approved type SPT-2 or heavier type, 2 × 18 AWG
cord with a 125 V 10 A plug and 125 V 7 A connector.