Fitting Other Guards And Cutting Attachments - Husqvarna 232L Operator's Manual

• Fit the nut (G). Tighten the nut to a torque of 35-50 Nm
(3.5-5 kpm). Use the socket spanner in the tool kit. Grasp
the handle of the spanner as close to the trimmer guard
as possible. To tighten the nut, turn the spanner in the
opposite direction to the direction of rotation (Caution! left-
hand thread).
• Fit the bottom half of the trimmer head (K) to the cover (I)
by pressing them together, with the cut-outs on the bottom
half aligned with the catches on the cover.
• To dismantle, follow the instructions in the reverse order.
Fitting other guards and cutting
attachments
A
L
B
C
M
• Fit the trimmer guard/combination guard (A) intended for
use with the trimmer head/plastic blades. Secure the
trimmer guard/combination guard using four screws (L)
and the support plate (M) as shown.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
• To dismantle, follow the instructions in the reverse order.
ASSEMBLY
H
– 11
English