Sles 10 Agent Does Not Autostart After Power Fail Or Reboot; Servers Running Windows® Server 2003 Do Not Restart; Shutdowns Not Functioning When Any Server Is Configured In A Redundant Configuration; Silent Install Did Not Execute Successfully - HP A1353A User Manual

Events
Two UPSs are on battery power and
redundant power is lost
Two UPSs have shut down
Both UPSs have lost communication
SLES 10 agent does not autostart after power fail or
reboot
Action: Follow the instructions for installing the agent on SLES 10 (on page 35).
Servers running Windows® Server 2003 do not
restart
Symptom: Servers running Windows® Server 2003 do not restart upon power restoration following a
power fail shutdown.
Possible Cause: This is a known Windows® Server 2003 behavior on some servers.
Action: Refer to the Microsoft® Knowledge Base article 819760.
Shutdowns not functioning when Any Server is
configured in a redundant configuration
Action: Reconfigure the management server information on the agent.
Open the agent configuration program for your operating system.
1.
Windows
o
Linux
o
HP-UX
o
Enter the correct IP address, host name, communications port, or serial path for the first management
2.
server that should communicate with the agent. Do not select Any Server from the dropdown box in
Windows or enter an asterisk (*) where prompted for Linux or HP-UX.
Enter the correct IP address, host name, communications port, or serial path for the second
3.
management server that should communicate with the agent. Do not select Any Server from the
dropdown box in Windows or enter an asterisk (*) where prompted for Linux or HP-UX.
Close the configuration program.
4.

Silent install did not execute successfully

Action:
("Reconfiguring the agent on Windows operating
("Reconfiguring the agent on Linux operating
("Reconfiguring the agent on HP-UX operating
Agent status Management
Server 1 status
- -
systems" on page 36)
systems" on page 39)
Management
Server 2 status
- - -
systems" on page 32)
Troubleshooting 95