Reset Button - HP hn200w Owner's Manual

wireless gateway
Uplink Port
Power
Antenna Jacks

reset button

To refresh Gateway connections and attempt to fix routing problems, very briefly
depress the Reset button with a paper clip.
If you have exhausted all troubleshooting options (see the Troubleshooting section of
this user's guide) and continue to experience serious routing problems, depress the
Reset button for about five seconds to clear all of the Gateway data and restore
the factory default settings.
Warning:
addresses and what the Gateway expects them to be. You may be forced to restart the
entire system.
If the Gateway locks up, unplug the Power Adapter from the Gateway's Power Port
for 3 to 5 seconds (but not longer) and then plug it back in. Leaving the power off
for too long could result in the loss of network connections.
8
You can connect a cable from another
switch, router, or hub to the Uplink port to
add it to your network. Since the Uplink
port shares wiring with LAN Port 4, port 4
will be disabled if a cable is plugged into
the Uplink port (and vice versa).
You will connect the included AC Power
Adapter to the Power port.
Connect the included antennas to the
antenna jacks.
Resetting the Gateway may create conflicts between your PC's actual IP