Hp Support Services - HP 3C905B-TX Installation Manual

NOTE
HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide
The PC Cannot Be Started or Woken up from the Network
Check that the WOL connector cable is connected to the network
interface card and to the PC's system board.
If the PC has been powered off (for example, due to an electrical
•
power failure, or because the power cord has been removed), the
Remote Power On (RPO) will not work. To enable the RPO, you must
first power on the PC, allow Windows 95 or NT 4.0 to boot, then shut
down the PC.
Check that the WOL connector cable is connected to the network
•
interface card and to the PC's system board.
Check that the LAN-specific fields in the HP PC Setup utility are
•
correctly set (refer to refer to "Updating LAN-specific Fields in the
HP PC Setup Utility" on page 9).
RPO is only supported under Windows 95 and Windows NT 4.0.

HP Support Services

The latest drivers and utilities are available on HP's Web site at:
http://www.hp.com/go/vectrasupport
HP Support Services
English 15