Zanussi ZWT 71401 WA User Manual

Zanussi ZWT 71401 WA User Manual

Washer-dryer
Hide thumbs Also See for ZWT 71401 WA:

Advertisement

User manual
EN
Washer-dryer
ZWT 71401 WA

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZWT 71401 WA

  • Page 1 User manual Washer-dryer ZWT 71401 WA...
  • Page 2: Table Of Contents

    • Make sure that small pets and children do not climb use. Serious damage can occur to the product and to into the drum. To avoid this, please check into the property if this is not adhered to. See relevant section drum before using. in the user manual. www.zanussi.com...
  • Page 3 If necessary use a coin. To disa- • Never tumble dry items that have had contact with ble this device and restore the possibility of closing the chemicals such as dry cleaning fluid. These are of a volatile nature and could cause an explosion. Only www.zanussi.com...
  • Page 4: Product Description

    Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows total use of detergent and reduces water consumption so saving energy. Detergent dispenser drawer Rating Plate Control panel Drain pump Door opening handle Adjustable feet www.zanussi.com...
  • Page 5: Control Panel

    It allows you to switch the appliance on/off and/or to se- lect a programme. EXTRA RINSE button Spin DRYING TIME button By pressing this button you can change the spin speed of EASY IRON button the selected programme or to select Rinse Hold option. Display www.zanussi.com...
  • Page 6 = 2.10 ). After the programme has started the time After selecting a programme, the duration is displayed remaining is updated every minute. in hours and minutes (for example 2.05 ). The duration • Delayed start is calculated automatically on the basis of the maxi- www.zanussi.com...
  • Page 7: First Use

    There is a risk of water leakage or damage to the laundry. Measure out the detergent and the fabric softener Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment or in the appropriate compartment www.zanussi.com...
  • Page 8 8 will blink 3 times and the Press button 10 once until the symbol ’ is dis- message Err is displayed to indicate a wrong selection. played The machine will not perform the new selected programme. Press button 8 again to start the programme. www.zanussi.com...
  • Page 9: Use - Drying

    By pressing Drying Time button it is also possible Select the drying programme for Cottons or Synthet- to dry up to 4 kg of cotton items (see the «Drying ic in the Drying sector of the programme selector di- Programme » table). Warning! www.zanussi.com...
  • Page 10: Helpful Hints And Tips

    3 kg for cotton and 1,5 kg for synthetic. Helpful hints and tips Sorting out the laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, wool- lens. www.zanussi.com...
  • Page 11 Ink: depending on the type of ink, moisten the fabric first Laundry weights with acetone , then with acetic acid; treat any residual The following weights are indicative: marks on white fabrics with bleach and then rinse thor- oughly. 1) do not use acetone on artificial silk www.zanussi.com...
  • Page 12: Drying Hints

    • Avoid drying dark clothes with light coloured fluffy items such as towels as these can attract the fluff. www.zanussi.com...
  • Page 13: Washing Programmes

    ECONOMY 90°-40° SUPER QUICK Prewash - Main wash - Rinses EXTRA RINSE Long spin at maximum speed EASY IRON Max. load 7 kg - Reduced load 3,5 kg For white or coloured cottons with prewash phase (heavily soiled items). www.zanussi.com...
  • Page 14 (Cold) Main wash - Rinses Short spin at 900 rpm Max. load 2 kg Special programme for delicate fabrics with «hand washing» care symbol and machine washable wollens. — DRYING PROGRAMME — COTTON DRYING Drying programme for cotton items www.zanussi.com...
  • Page 15 1) If you select the Super Quick option by pressing button 3, we recommend that you reduce the maximum load as indicated. Full loading is possible however with somewhat reduced cleaning results. 2) This option can be selected at the temperature of 40°C or higher only. 3) If using liquid detergents, a programme without PREWASH must be selected. www.zanussi.com...
  • Page 16: Drying Programmes

    Clean the exterior cabinet of the appliance with soap and of accumulated powder. water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. www.zanussi.com...
  • Page 17 (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: www.zanussi.com...
  • Page 18: What To Do If

    • : problem with the water supply. During machine operation it is possible that the red pilot • : problem with the water draining. light of button 8 blinks, one of the following alarm codes www.zanussi.com...
  • Page 19 An option or a programme that ends with the water still in the tub or that elimi- does not spin: nates all the spinning phases has been selected. • Select the draining or spinning programme. The laundry is not evenly distributed in the drum. • Redistribute the laundry. www.zanussi.com...
  • Page 20 • Check the correct levelling of the appliance. The machine vibrates is noisy: The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry. www.zanussi.com...
  • Page 21: Technical Data

    Mod..the Service Centre will require this information. Prod. No..Ser. No..Technical data Dimensions Width 60 cm Height 82 cm Depth 54 cm www.zanussi.com...
  • Page 22: Consumption Values

    You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. After removing all the packaging, carefully lay ma- chine on it’s back to remove the polystyrene base from the bottom. www.zanussi.com...
  • Page 23 Remove the bracket D and tighten up the six smaller bolts C. Unscrew and remove the central rear bolt A with the supplied spanner . Slide out the relevant plastic spacer. Unscrew and remove the two large rear bolts B and the six smaller bolts C. www.zanussi.com...
  • Page 24 After having levelled the and you do not wish to move the tap, you will have to pur- appliance, tighten the lock nuts. chase a new, longer hose specially designed for this type of use. www.zanussi.com...
  • Page 25: Building In

    The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. Building in This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in picture A. www.zanussi.com...
  • Page 26 Its position must cor- - thickness 16-22 mm respond to the magnet (4) on the appliance (see picture The height (C-Fig. C) depends on the height of the adja- cent furniture's base. www.zanussi.com...
  • Page 27: Electrical Connection

    • With adequate pre-treatment, stains and limited soiling Packaging materials can be removed; the laundry can then be washed at a The materials marked with the symbol are recyclable. lower temperature. >PE<=polyethylene www.zanussi.com...
  • Page 28 • Measure out detergent according to the water hard- ness, the degree of soiling and the quantity of laundry being washed. www.zanussi.com...
  • Page 29 www.zanussi.com...
  • Page 30 www.zanussi.com...
  • Page 31 www.zanussi.com...
  • Page 32 www.zanussi.com/shop...

Table of Contents