HP 600 Series User Manual page 35

The HP Jornada uses a serial connection to communicate with a desktop PC.
Use the sync cable that was included with your HP Jornada to connect the
docking cradle or the device to a 9-pin serial communications port on your
desktop PC. If the 9-pin serial port on your PC is in use by another device, or
if your computer has no 9-pin serial port, you can obtain an adapter from your
computer's manufacturer.
Resetting
1. Connect the 9-pin end of the sync cable to a serial port on your
desktop PC.
2. Fully insert the flat end of the sync cable, arrow side up, into the
serial port on the back of the docking cradle.
3. Turn off your HP Jornada and disconnect any cables (telephone
cable, AC adapter, sync cable, etc.) from your HP Jornada.
4. Connect the AC adapter to the DC jack on the back of the docking
cradle, and then plug in the power cable.
5. Align your HP Jornada in the docking cradle, and push down firmly
until the HP Jornada snaps into place.
Your HP Jornada should start automatically and establish a connection to the
desktop computer. To remove your HP Jornada from the docking cradle, push
the release button on the cradle, and carefully lift your HP Jornada from the
cradle.
| |