Getting Started HP Business Notebook PC Document Part Number: 443562-001 June 2007 This guide explains how to set up your hardware and software, and begin using the computer in Windows®.
Page 2
Hewlett-Packard Company under license. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty.
Identifying required hardware To set up the computer for the first time, you will need the computer, the AC adapter, the power cord, and the primary battery. Components included with the computer may vary by region or country and by model. Component Power cord AC adapter...
First-time setup Setting up the computer Computer setup involves the following tasks: 1. Inserting the battery into the computer 2. Connecting the computer to external power The battery begins to charge. 3. Turning on the computer 4. Setting up the software 5.
First-time setup Step 2: Connect the computer to external power Power cords and AC outlets vary in appearance by region and country. To connect the computer to external AC power: 1. Plug the AC adapter into the power connector 1 on the computer.
First-time setup Step 3: Turn on the computer To open the computer: 1. Slide the display release latch 1 to the right to release the display. 2. Raise the display 2. To turn on the computer: » Press the power button 1. The power light on the power button 2 turns on.
Step 5: Create recovery discs (recommended) You can create a set of recovery discs of your full factory image using HP Backup & Recovery Manager. You can use the recovery discs to start up (boot) the computer and restore the operating system and software programs to factory settings in case of system failure or instability.
Quick tour Identifying required hardware Components included with the computer may vary by region and model. The illustrations in this chapter identify the standard features included on most computer models. Getting Started 2–1...
Quick tour Right-side components Computer features vary depending on model. Refer to one of the following illustrations. Component PC Card slot (select models only) Media Card Reader 1394a port Audio-out (headphone) jack Audio-in (microphone) jack 2–4 Component USB port External monitor port Vent Docking connector Getting Started...
Component Smart card reader (select models only) Media Card Reader 1394a port Audio-out (headphone) jack Audio-in (microphone) jack Rear components Component RJ-45 (network) jack Getting Started Component USB port External monitor port Vent Docking connector Component Security cable slot Quick tour 2–5...
Quick tour Wireless antennae Two antennae send and receive wireless signals to communicate with wireless local area networks (WLANs) and wireless wide area networks (WWANs). The antennae are not visible from the outside of the computer. To see wireless regulatory notices, refer to the section of the Regulatory, Safety and Environmental Notices that applies to your country or region.
Protecting the computer The information in this section explains how your computer can be protected from damage caused by a virus, a security breach, a power surge, unsafe operation, or system failure. Protecting the computer from viruses When you use the computer for e-mail, network, or Internet access, you expose it to computer viruses that can disable the operating system, applications, or utilities or cause them to function abnormally.
Next steps Protecting your system files The HP Backup & Recovery Manager provides several ways to back up the system and to recover optimal system functionality. Refer to Appendix A, “Backup and recovery,” for additional information. Protecting your privacy When you use the computer for e-mail, network, or Internet access, it is possible for unauthorized persons to obtain information about you or the computer.
WARNING: Å or battery provided with the computer, a replacement AC adapter or battery provided by HP, or a compatible AC adapter or battery purchased as an accessory from HP. For more safety and regulatory information, and for battery disposal information, refer to the Regulatory, Safety and Environmental Notices located in Help and Support.
Next steps Connecting to a computer network The computer may have the following networking capabilities: Local area network (LAN) Wireless local area network (WLAN) Wireless wide area network (WWAN) Bluetooth® If you plan to connect the computer to a home office LAN or WLAN, refer to Help and Support for information on networking.
Installing additional hardware and software Identifying and installing hardware To see a list of hardware installed on the computer, follow these steps: 1. Select Start > Computer > System properties. 2. In the left pane, click Device Manager. Windows includes the User Account Control feature to improve the security of your computer.
Next steps Preloaded software. This is software provided on the hard drive but not ready to use. To locate or install preloaded software or drivers, follow these steps: a. Select Start > All Programs > Software Setup. b. Follow the on-screen instructions and select the check box next to the software program or driver you want to install.
Turning off the computer correctly Whenever possible, turn off the computer by using the standard shutdown procedure: 1. Save your work and close all open applications. 2. Shut down the computer through the operating system by clicking Start, clicking the arrow next to the Lock button, and then clicking Shut Down.
Troubleshooting resources If you experience computer problems, perform these troubleshooting steps in the order provided until the problem is resolved: Refer to “Quick troubleshooting,” the next section in this chapter. Access additional information about the computer and Web site links through Help and Support. Select Start > Help and Support.
Page 27
Troubleshooting The following suggestions may help you determine why the computer will not start up: If the computer is plugged into an AC outlet, be sure that the AC outlet is providing adequate power by plugging another electrical device into the outlet. If the power light on the front of the computer is blinking rapidly, replace the AC adapter with one having a higher power rating, and then plug the adapter into an AC...
The computer screen is blank If the computer is on but the screen is blank: the computer may be in the Sleep state or in Hibernation; the computer may not be set to display the image on the computer screen; or the display switch may not be functioning properly.
Troubleshooting Software is functioning abnormally Follow these suggestions if the software becomes unresponsive or responds abnormally: Restart the computer by clicking Start, clicking the arrow next to the Lock button, and then clicking Restart. If you cannot restart the computer using this procedure, refer to the next section, “The computer is turned on but not responding.”...
The computer is unusually warm It is normal for the computer to feel warm to the touch while it is in use. But if the computer feels unusually warm, it may be overheating because a vent is blocked. If you suspect that the computer is overheating, allow the computer to cool to room temperature.
Troubleshooting The WLAN connection is not working If a WLAN connection is not working as expected, follow these suggestions: Be sure that the wireless light on the computer is on. If the light is off, press the wireless button to turn it on. Be sure that the computer wireless antennae are free from obstructions.
Checkups for computer functionality Automated and interactive troubleshooting, repair solutions, and system recovery procedures Links to community forums of IT experts Contacting technical support If the computer is connected to the Internet, select Start > Help and Support > Contact support to get online help or to access the technical support telephone numbers.
Note the following guidelines before creating recovery discs: You will need high-quality CD-R, DVD-R, or DVD+R discs (purchased separately). Read-write discs, such as CD-RW and DVD+/-RW discs, are not compatible with HP Backup & Recovery Manager. The computer must be connected to AC power during the process.
Backup and recovery To create a set of recovery discs, 1. Select Start > All Programs > HP Backup & Recovery > Backup & Recovery Manager. 2. Click Next. 3. Click Create a set of recovery discs (Recommended), and then click Next.
Drivers, utilities, and applications installed by HP can be copied to a CD or to a DVD using HP Backup & Recovery Manager. Backing up specific files or folders You can back up specific files or folders to the recovery partition on the hard drive, to an optional external hard drive, or to optical discs (CDs or DVDs).
Backup and recovery To back up specific files or folders: 1. Select Start > All Programs > HP Backup & Recovery > Backup & Recovery Manager. 2. Click Next. 3. Click Create or manage backups, and then click Next. 4. Click Back up user created files and folders and then click Next.
Recovering to an earlier recovery point does not affect data files or e-mails created since that recovery point. To create a system recovery point: 1. Select Start > All Programs > HP Backup & Recovery > Backup & Recovery Manager. 2. Click Next.
Backup and recovery To schedule backups: 1. Select Start > All Programs > HP Backup & Recovery > HP Backup Scheduler. 2. Follow the on-screen instructions. Performing a recovery You can only recover files that you have previously backed up. HP recommends that you use HP Backup &...
Initiating a recovery in Windows To initiate a recovery in Windows, follow these steps: 1. Back up all personal files. 2. Select Start > All Programs > HP Backup & Recovery > HP Backup and Recovery Manager. 3. Click Next.
Operating environment The operating environment information in the following table may be helpful if you plan to use or transport the computer in extreme environments. Factor Temperature Operating (not writing to optical disc) Operating (writing to optical disc) Nonoperating Relative humidity (noncondensing) Operating Nonoperating Maximum altitude (unpressurized)
DC power source, it should be powered only with an AC adapter or a DC power source supplied and approved by HP for use with this computer. The computer is capable of accepting DC power within the following specifications.
Page 42
1394a port 2–4 2–5 AC adapter connecting 1–3 identifying 1–1 altitude specifications B–1 ambient light sensor 2–7 antennae, wireless 2–8 antivirus software 4–4 audio-in (microphone) jack 2–4 2–5 audio-out (headphone) jack 2–4 2–5 battery charging 1–3 identifying 1–1 inserting 1–2 battery bay, identifying 2–6 battery light behavior 1–3...
Page 43
4–5 external monitor port 2–4 firewalls 3–2 hard drive bay, identifying 2–6 Help and Support 4–6 Hibernation 4–3 HP Fingerprint Sensor 2–2 humidity specifications B–1 IEC 60950 compliance 3–3 image, switching among display devices 4–3 info button, identifying 2–2 inserting the battery 1–2...
Page 44
optical drive light 2–3 overheating, computer 3–3 4–5 PC Card slot 2–4 pointing stick 2–2 pointing stick buttons 2–2 ports 1394a 2–4 2–5 external monitor 2–4 USB 2–3 2–4 2–5 power running the computer on battery 1–3 1–4 turning on computer 1–4 4–1 power button, identifying 2–2 power connector...