HP 2140 User Manual page 50

LCD error messages
(continued)
Display
Memory Full
Press OK to continue
Status/Solution
Memory has become full while scanning a document. Press OK
to send or copy the scanned pages only. To cancel the job press
Cancel and try again when memory becomes available, or split
the new document into smaller parts. See Clearing memory on
page 36.
Memory Received The machine has data stored in memory. Replace the print
Ink Low. Install new cartridge with new one in order to print the faxes.
ink cartridge
Memory Received Load paper and press OK. There might be a jam. Clear the jam
Load paper and as described in Paper jams during printing on page 41.
press OK
Memory Received There is no print cartridge in the machine. Install a print cartridge.
Install ink
cartridge
No answer from
The other machine has not answered after all redial attempts to
remote fax
send a fax.
No CID Number
The machine could not detect the CID (Caller ID) number.
No Dial Number There is no number in the redial memory.
Not _v_iZ_ble while The machine could not receive a new fax while printing the
reprinting fax
stored faxes.
Not Found
The number you are searching for does not exist in memory.
Number already
The number you are trying to enter already exists in the phone
registered
book or junk fax list.
Number Not Assigned There is no number assigned to this One-Touch or two-digit
Speed number.
Poll Code Error
The remote user entered the wrong poll code.
Poll
job exists
You have already programmed a polling send. Cancel scheduled
already
job and try again.
Polling
Error
The machine you want to poll is not ready to answer your poll.
Check remote site
Check with the other person.
Receiving Error.
There is an error while receiving a fax.
Ask sender to
try again.
Remove jammed
document
The document you are sending has jammed in the document
feeder. To clear the document jam, see Document jams during
transmission on page 41.
You tried to copy or fax a document which is longer than 390 mm
(15.4 in.).
Care and maintenance 47