Bosch APC-AMC2-4W Installation Manual page 43

AMC2 4W
Fig. 5.20 Schema of the using of the recovery diode
Risk of Damage!
!
Do not connect externally powered devices in wet mode. This
can damage the AMC2 4W.
NOTE!
i
A complete connection diagram of the relay output connectors
is shown in Figure 7.9.
Each relay output has a separate jumper setting on the bottom
side of the lower circuit board to activate wet (D2)or dry (D1)
mode.
Bosch Security Systems Installation manual
Installing | en 43
F.01U.024.965 | V.4 | 2006.09