Step 2 - Connect To A Gas Supply Line (Gas Dryer Only) - Haier GDE560BW User Manual

STEP 2 - CONNECT TO A GAS SUPPLY LINE
(GAS DRYER ONLY)
NOTE: Do not connect the dryer to an LP gas line without rst converting the
dryer with a conversion kit. An LP conversion kit must be installed by a quali ed
technician.
NOTE: Apply a pipe-joint compound that that is resistant to the action of LP gas to
all males threads. Do not use plumber's tape.
1. Turn the gas supply o by moving the shuto valve to the closed position.
Closed Valve
Open Valve
2. Disconnect and discard old exible gas connector. Replace with a new
CSA(AGA) approved exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a " NPT elbow to the gas inlet pipe on the dryer. Then connect a are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
Gas Inlet Pipe on
the Dryer
" NPT Elbow
" NPT Flare Adapter
5. Connect the dryer to the gas supply line with a exible gas connector.
Flexible Gas Connector
6. Tighten the exible gas connector using two adjustable wrenches.
18
A
A
B
B
C
A